Lanmage 6600C - Collimator Operation

6600 Product Manual
Operator Manual
37
straight arm assembly will automatically lock at the current
height.
2
Straight arm down
button
Press and hold the key, the whole straight arm will move
downward along the column guide rail; within the allowable
range of limit, release the key, the straight arm assembly will
automatically lock at the current height.
3
SID decrease
button
Press and hold the key, the X-ray tube assembly will move
towards the near end of the flat panel detector along the
straight arm; within the allowable limit range, release the key,
the X-ray tube assembly will be automatically locked in the
current Sid.
4
SID add button
Press and hold the key, the X-ray tube assembly will move
to the far end of the flat panel detector along the straight arm;
Release the key within the allowable limit range, the X-ray
tube assembly will automatically lock in the current Sid.
5
The straight arm
rotates clockwise.
Press and hold the key, and the straight arm rotates
clockwise. Within the limit range, release the key, and the
straight arm will automatically lock at the current angle.
6
The straight arm
rotates
counterclockwise
press and hold the key, the straight arm rotates
counterclockwise, within the limit range, release the key, the
straight arm will automatically lock at the current angle.
7
1.0 m in place with
one key
Press the key, the device will automatically run to the preset
position.
8
1.8m one key in
place
Press the key, the device will automatically run to the preset
position.
9
One key under the
bed
Press this key, the device will automatically run to the preset
position.
5.5 Collimator operation
The collimator control section includes one indicator switch button and two lead leaf
opening and closing adjustment knobs. Adjusting the front bezel knob 1 can drive the
vertical lead leaf and the horizontal lead leaf to open and close to adjust the X-ray radiation