This device complies with EMC regulations, depending on the intended use. This
includes the level of electromagnetic interference allowed by the regulations and the
required electromagnetic shielding performance.
Complete elimination of electromagnetic interference is almost impossible unless all
devices that may generate high frequency signals are excluded. Although some high-
frequency devices are themselves compliant with EMC regulations, when they operate at
considerable power near the device, it is not possible to determine whether the radio
signals generated by their high-frequency transmitters will affect the normal operation of
the device. Therefore, the use of the above-mentioned radio equipment such as a mobile
phone, a wireless microphone or the like in the vicinity of the X-ray system should be
avoided as much as possible to eliminate the occurrence of interference.
Explanation：
Meeting the requirements of EMC for electronic equipment means that there is no
risk of malfunction due to electromagnetic interference under normal operating conditions.
However, for relatively high power radio signals from high frequency transmitters, the
electromagnetic interference generated by their use in the vicinity of electronic equipment
cannot be completely ruled out. Therefore, the transmission of all mobile radios is
prohibited in the vicinity of the electronic device. The mobile phone must be turned off in a
specific area.
2.9 Conventional spatial resolution detection
Measuring method：
1. Set SID to 100cm bed position;
2. Place the spatial resolution test card at the center of the detector surface and make
the line-to-card line at an angle of 45° to each side of the detector;
3. Open the Test DR control application, start the detector and high voltage, and if the
To Next Page