44
LeeBoy 8520C Conveyor Paver 4-21
Operation
Perform Parked RegenerationPerform Parked Regeneration
The DPF must be at Level 2 or higher to perform parked
regeneration. You will not be able to performed parked
regeneration if other engine faults are present. (Figure
4-43)
Any engine fault must be resolved to perform parked
regeneration. Warning/alert icons will appear in the top
banner on the screen. (Refer to Table 4-4, Status and
Warning Alert Icons on Page 4-24) Fault codes may
also appear on the screen. (A complete listing of Fault
Codes is shown in Troubleshooting, Section 5.)
If engine faults are present that pre-
vent the ability to perform parked regeneration, DPF
levels will continue to rise. If the DPF level increases
to Level 4, the engine will become inoperable and
require authorized dealer technician intervention. It
is important to resolve any engine faults immediately
and perform the needed regeneration to prevent
costly DPF technician service if DPF level warnings
or engine faults are ignored.
Figure 4-43. Engine Fault DPF Notication Screen
During regeneration, EXHAUST TEM-
PERATURES WILL BE EXTREMELY HIGH. BE SURE
EXHAUST WILL NOT COME INTO CONTACT WITH
ANY COMBUSTIBLE MATERIALS.
Continue to monitor surrounding areas
during the process. If unsafe conditions develop,
shut the unit off immediately.
Using the (V) button (#2), scroll to the remainder of the
message: The DPF must be cleaned by a qualied
cleaning facility and the ECU must be reset by a qualied
engine or OEM service technician. IMMEDIATELY take
the machine to a safe location, shut down, and contact a
qualied service technician. (Figure 4-42)
Figure 4-42. Regen Level 5 Warning
To Next Page
Loading...
