Lenze L-force 8400 BaseLine D - Page 86

8400 BaseLine D | Software Manual
Motor control (MCTRL)
Selection of the operating mode
86 L Firmware 03.00 - DMS EN 5.0 - 07/2009
Overview of the relevant parameters
Parameter INFO
C6
Selection of the operating mode for V/f characteristic control without
feedback with
• value "6" for linear characteristic or
• value "8" for quadratic characteristic
C011
Reference speed
C018
Switching frequency
C021
Slip compensation
C022
Current limit (in motor mode)
C023
Current limit (in generator mode)
C057
Maximum torque
C081
Rated motor power
C084
Motor stator resistance
C085
Motor stator leakage inductance
C087
Rated motor speed
C088
Rated motor current
C089
Rated motor frequency
C090
Rated motor voltage
C091
Motor cosine phi
C092
Mutual motor inductance
C097
Rated motor torque
C909/1 /2
Maximum positive / negative speed
C910/1 /2
Maximum positive / negative output frequency