Leuze BPS 348i - Twin Tapes; Repair Tapes

Order guide and accessories
Leuze electronic GmbH + Co. KG BPS 348i 125
14.5.3 Twin tapes
Twin tapes are special bar code tapes and are produced according to customer specifications.
Tab.14.12: Data for Twin tapes
Feature Value
Grid dimensions 30mm (BCBG30…)
40mm (BCBG40…)
Height 20mm–140mm in millimeter increments
Length According to customer specifications, maximum 10,000m
Tape start value According to customer specifications, dependent on grid dimen-
sion
Tape end value According to customer specifications, dependent on grid dimen-
sion, maximum tape end value at 10,000m
• Two identical tapes are delivered in one package. The tape values as well as the tape tolerances are
identical on both tapes. The tapes are printed with the position value in plain text below and above the
bar code.
• Twin tapes over 300m in length are wound and delivered on multiple rolls.
An entry wizard for twin tapes with custom tape start value, tape end value, custom length and height is
available on the Leuze website under devices BPS300 - Accessories tab. The entry wizard provides sup-
port when entering the individual pieces of tape data and creates a query or order form with the correct part
number and type designation.
14.5.4 Repair tapes
Repair tapes are produced according to customer specifications.
Tab.14.13: Data for repair tapes
Feature Value
Grid dimensions 30mm (BCBG30…)
40mm (BCBG40…)
Height 47mm
25mm
Length According to customer specifications, maximum 5m
Tape start value According to customer specifications, dependent on grid dimen-
sion
Tape end value According to customer specifications, dependent on grid dimen-
sion
• Repair tapes longer than 5m must be ordered as special tapes.
• Repair tapes are printed below the bar code with the corresponding position value.
• Repair tapes are usually delivered wound on a roll.
An entry wizard is available for repair tapes on the Leuze website under devices BPS300 - Accessories
tab. The entry wizard provides support when entering the individual pieces of tape data and creates a
query or order form with the correct part number and type designation.