Leuze BPS 348i - Module 25 - Device Status; Module 26 - Extended Status

Starting up the device – Basic configuration
Leuze electronic GmbH + Co. KG BPS 348i 90
Parameter Rel.
addr.
Data type Value range De-
fault
Unit Explanation
Metr. Inc
h
Error thresh-
old reading
quality
1 unsign
8 bit
10…70 30 ------------- Below this threshold for
reading quality in units of
[%], the BPS generates an
error event.
Reading
quality
smoothing
2 unsign
8 bit
0…100 5 ------------- Insensitivity towards
changes of the quality.
The higher this value is,
the less of an effect a
change has on the reading
quality.
Input data Rel.
addr.
Data type Value range Init
value
Unit Explanation
Metr. Inc
h
Reading quality 0 unsign
8 bit
0…100 0 % % Reading quality in units of
[%] as smoothed value,
dependent on the Smooth-
ing of reading quality pa-
rameter.
8.4.24 Module25–Device status
Module ID:1025 with submodule ID:1
• The module signals various device states via input data.
• The module contains input data (with input data length of 1byte), but no parameters and no output
data.
Input data Rel.
addr.
Data
type
Value range Init
value
Unit Explanation
Metr. Inch
Device status 0 unsign
8 bit
0: Initial value
1: Initialization
10: Standby
11: Service
12: Diagnostics
15: Device is ready
128: Error
129: Warning
0 ------------- This byte represents
the current device sta-
tus.
The following event
messages can be ac-
knowledged via mod-
ule 6 - status and con-
trol (output data bit
0.3):
128: Error
129: Warning
Input data length: 1byte
8.4.25 Module26–Extended status
Module ID:1026 with submodule ID:1
• Via input data, the module signals various pieces of extended status information, such as the current
read direction of the bar code tape.
• The module contains input data (with input data length of 2bytes), but no parameters and no output
data.