Leuze BPS 348i - System Requirements; Install USB Driver

Starting up the device – webConfig tool
Leuze electronic GmbH + Co. KG BPS 348i 93
9.1.1 System requirements
NOTICE
Regularly update the operating system and the Internet browser.
Install the current Windows Service Packs.
Tab.9.1: webConfig system requirements
Operating system Windows10 (recommended)
Windows8, 8.1
Windows7
Computer PC, laptop or tablet with USB interface, version 1.1 or higher
Graphics card Min. resolution: 1280x800 pixels
Required disk space for USB
driver
10MB
Internet browser Recommended is a current version of
Mozilla Firefox
Google Chrome
Microsoft Edge
Note: Other Internet browsers are possible but have not been tested
with the current device firmware.
9.1.2 Install USB driver
Ä Start your PC with administrator privileges and log on.
Ä Download the setup program from the Internet:
www.leuze.com >Products >Measuring Sensors >Bar Code Positioning Systems >BPS300i
>(Name of the BPS) >TabDownloads >Software/driver.
Ä Start the setup program and follow the instructions.
NOTICE
Alternatively, you can manually install the LEO_RNDIS.inf USB driver.
Contact your network administrator if the installation fails.