Leuze BPS 348i - Module 14 - Static Speed Limit Value 4

Starting up the device – Basic configuration
Leuze electronic GmbH + Co. KG BPS 348i 83
Parameter Rel.
addr.
Data
type
Value range De-
fault
Unit Explanation
Metr. Inch
Switching type 0.0 Bit 0…1 0 ------------- Condition for the
Speed limit value3 sig-
nal, which applies to
the switching output
(module4/5) and the
status bit (module16):
0: Exceeded
1: Below minimum
value
Direction selec-
tion
0.1 Bit 0…1 0 ------------- Selection of the limit
value check:
0: Direction indepen-
dent
1: Direction dependent
Speed limit
value3
1…2 unsign
16 bit
0…+20,000 0 mm/s (in/100)/s Limit value is com-
pared to the current
speed.
Speed hystere-
sis3
3…4 unsign
16 bit
0…1,000 100 mm/s (in/100)/s Relative shift of the
switching point to pre-
vent signal bouncing.
Limit value3
range start
5…8 sign
32 bit
-10,000,000
…
+10,000,000
0 mm in/100 The speed limit value
is monitored beginning
at this position.
Limit value3
range end
9…12 sign
32 bit
-10,000,000
…
+10,000,000
0 mm in/100 The speed limit value
is monitored up to this
position.
8.4.16 Module14–Static speed limit value4
Module ID:1014 with submodule ID:1
• The module provides all parameters for the Static speed limit value4 function.
• Further explanations on the Range start and Range end parameters see chapter 8.4.13 "Module11–
Static speed limit value1".
• The module contains parameters (with parameter data length of 13bytes), but no input data and no
output data.
Parameter Rel.
addr.
Data
type
Value range Default Unit Explanation
Metr. Inch
Switching type 0.0 Bit 0…1 0 ------------- Condition for the
Speed limit value4
signal, which applies
to the switching output
(module4/5) and the
status bit (module16):
0: Exceeded
1: Below minimum
value