Leuze BPS 348i - Page 79

Starting up the device – Basic configuration
Leuze electronic GmbH + Co. KG BPS 348i 79
• If there is a brief disturbance in the position value or the speed calculation in the device, the BPS sends
the last valid measurement value for a configured time.
• If the BPS can again calculate valid measurement values within the error delay time, these are output.
The disturbance is made evident only as a small increase in the output measurement value.
• If the problem with the calculation lasts for a longer period of time, it is possible to configure how the
BPS is to behave.
• The module contains parameters (with parameter data length of 8bytes), but no input data and no out-
put data.
Parameter Rel.
addr.
Data
type
Value
range
Default Unit Explanation
Metr. Inch
Position value in
the case of fail-
ure
0.0…0.1 Bit 0…1 1 ------------- Position value in the case of
an error after the error delay
time elapses:
0: Last valid value
1: Zero
Suppress posi-
tion status
0.2 Bit 0…1 1 ------------- Status bit (module6bit0.0)
in the case of an error:
0: OFF (status bit is set im-
mediately)
1: ON (status bit is sup-
pressed for the configured
error delay time)
Error delay (posi-
tion)
0.3 Bit 0…1 1 ------------- Position value in the case of
an error:
0: OFF (immediately the
value of the Position value in
the case of error parameter)
1: ON (the last valid position
value for the configured error
delay time)
Error delay time
(position)
1…2 unsign
16 bit
10…4,
000
50 1ms Errors that occur are sup-
pressed for the configured
time, i.e., if no valid position
value can be ascertained in
the configured time, the last
valid position value is always
output. If the error persists
after the time elapses, the
value of the Position value in
the case of error parameter
is output.
Speed in the
case of failure
3.0…
3.1
Bit 0…1 1 ------------- Speed value in the case of
an error after the error delay
time elapses (speed):
0: Last valid value is output
1: Zero is output
Suppress speed
status
3.2 Bit 0…1 1 ------------- Status bit (module16bit0.0)
in the case of an error:
0: OFF (status bit is set im-
mediately)
1: ON (status bit is sup-
pressed for the configured
error delay time)