Print media specifications and guidelines
62
Media specifications and guidelines
Do not remove trays while a job prints or while Busy displays on the control panel. Doing so may
cause a jam.
Loading the standard tray or the optional 250-sheet tray
The following instructions work for loading the standard tray or the tray for the optional 250-sheet
drawer.
Your MFP has one standard 250-sheet tray. You may use the optional 250-sheet drawer or the
optional 500-sheet drawer as a print media source; however, you may use only one of these options
at a time. See your Setup Guide for installation information.
For the sizes and types of print media these trays support, see Print media source specifications.
To load the tray for the optional 500-sheet drawer, see Loading the optional 500-sheet tray.
To load print media in a tray:
1 Remove the tray.
2 Press down on the metal plate until it locks into place.
To Next Page
Loading...
