Diagnostic aids 3-7
7541-03x
Accessing the service menus
There are different test menus that can be accessed during POR to identify problems with the printer.
Diagnostics menu 1. Turn off the printer.
2. Press and hold 3 and 6.
3. Turn on the printer.
4. Release the buttons when the splash screen
appears.
The Diagnostics menu group
contains the settings and
operations used while
manufacturing and servicing the
printer.
For more information, see
“Diagnostics mode” on
page 3-18.
Configuration menu 1. Turn off the printer.
2. Press and hold 2 and 6.
3. Turn on the printer.
4. Release the buttons when the splash screen
appears.
The Configuration menu group
contains a set of menus, settings,
and operations which are
infrequently required by a user.
Generally, the options made
available in this menu group are
used to configure a printer for
operation.
See “Configuration Menu” on
page 3-9 for more information.
Network SE menu While in Network/Ports Menu, press and hold 9, 7,
and 6.
SE menu At the printer, perform the following steps:
1. In the Admin menu, navigate to Network >
Ports > Standard Network > Std Network
Setup menu.
2. Press and hold 9, 7, and 6.
3. Release the buttons when the Network SE
Menu appears.
From a browser, add “/se” to the device IP address
(for example: http://158.183.3.2/se)
THe MFP does not need to be
restarted to enter this menu.
Invalid engine code
mode
1. Turn off the printer.
2. Press and hold 3, 4,and 6 (E+N+G).
3. Turn on the printer.
4. Release the buttons when the splash screen
appears.
This mode is used if the machine
has invalid code and needs the
correct code loaded. After
entering this mode, the firmware
code can be updated.
To Next Page
Loading...
