Lexmark X925 7541-03 series - Flatbed Assembly Removal

4-116 Service Manual
7541-03x
Go Back
Previous
Next
Flatbed assembly removal
1. Remove the op panel assembly. See “Op panel top cover” on page 4-13 and “Op panel bottom cover”
on page 4-15.
2. Remove the ADF assembly. See “ADF assembly removal” on page 4-113.
3. Remove the RIP cover. See “RIP cover” on page 4-5.
4. Remove the rear cover.See “Rear cover” on page 4-7.
5. Disconnect the flatbed cables (A) from the RIP.
6. Using a short handle screw driver, remove the two screws (B) on the left underside of the flatbed platform.
7. Using a short handle screw driver, remove the two screws (C) on the right underside of the flatbed
platform.
8. Remove the flatbed from the scanner platform.
9. Remove the flatbed front cover. See “Flatbed front cover” on page 4-117.
Note: After installing the new flatbed, perform the scanner calibration procedures. See “Adjustments” on
page 4-211.