Lexmark X925 7541-03 series - Engine Board and Mount Removal (Not a FRU)

Repair information 4-75
7541-03x
Go Back
Previous
Next
Engine board and mount removal (not a FRU)
1. Remove the HVPS unit. See “HVPS removal” on page 4-111.
2. Remove the rear fan. See “Rear fan” on page 4-102.
3. Disconnect the engine board fan cable from the engine board.
4. Disconnect all the cables from the engine board.
5. Remove the screw (A) from the upper right corner.
6. Remove the screw (B) from the lower right corner.