Lexmark X925 7541-03 series - Fuser Exit Drive Unit Motor Removal

Repair information 4-93
7541-03x
Go Back
Previous
Next
Fuser exit drive unit motor removal
1. Remove the rear EMI shield.See “Rear EMI shield – Not a FRU” on page 4-106.
2. Disconnect the cable from the connector (A) exit drive unit motor.
3. Remove the two screws (B) that secure the exit drive unit motor to the fuser motor damper.
Note: The ground wire (C) is connected with one of the screws. Be sure to replace the ground wire when
replacing the motor.