3-14 Service Manual
7541-03x
Color Alignment
Note: This menu item is not accessible in the Diagnostics menu.
To perform a color alignment, enter the administrative menus when the printer is in Ready state, and then
navigate to:
Settings > Print Settings > Quality Menu > Color Adjust
The printer will perform a color alignment, and then return to Ready state when the procedure is finished.
ADF Edge Erase
The ADF Edge Erase setting specifies, in millimeters, the size of a border around the scanned image that will be
erased. For copies, the printed page will always have a at least a 2-mm no-print border. The larger of the 2-mm
no-print border and the Edge Erase setting will be used in this situation.
FB Edge Erase
The FB Edge Erase setting specifies, in millimeters, the size of a border around the scanned image that will be
erased. For copies, the printed page will always have a at least a 2-mm no-print border. The larger of the 2-mm
no-print border and the Edge Erase setting will be used in this situation.
Scanner Manual Registration
Use this menu to adjust the scanner margins after you replace any of the following parts:
– Flatbed scanner assembly
– ADF unit assembly
– Flatbed scanner CCD assembly
For more information, see “Adjusting scanner registration” on page 4-212.
Note: The Scanner Manual Registration menu does not appear if Disable Scanner is set to Auto Disabled.
Disable Scanner
Use this setting to enable or disable the flatbed scanner and ADF.
Note: Auto Disabled can only be saved by the printer in response to failed scanner operation. Users cannot
save this setting.
Paper Prompts
Setting Paper Prompts controls which tray a change prompt is directed to when paper is sensed to be the wrong
size.
Envelope Prompts
Env Prompts controls which tray a change prompt is directed to when the envelopes are sensed to be the wrong
size.
To Next Page
Loading...
