Lexmark X925 7541-03 series - Density Sensor Removal

Repair information 4-57
7541-03x
Go Back
Previous
Next
Density sensor removal
1. Remove the LVPS. See “Low volt power supply removal” on page 4-51.
2. Remove the scanner power supply. See “Scanner power supply removal” on page 4-58.
3. Remove the 7 screws securing the power box shield to the printer frame.
4. Disconnect the density sensor harness from the density sensor.
5. Remove the two screws (D) fastening the density sensor to the frame.
B
C
D