Repair information 4-123
7541-03x
ICC board
1. Remove the ADF assembly from the flatbed. See “ADF assembly removal” on page 4-113.
2. Remove the flatbed assembly from the print engine.
3. Place the scanner, glass side down, on a non marring surface.
4. Remove the 5 screws securing the shield to the flatbed assembly.
5. Remove the shield from the flatbed assembly.
6. Remove the two screws that secure the ADF cable connector to the bottom shield.
7. Disconnect all the cables from the ICC board.
8. Remove the five screws (A) securing the board to the flatbed assembly.
To Next Page
Loading...
