Liebert Vertiv GXT5 - Page 66

Operation and Display Panel58
Power Factor
Power factor of the input power.
En
ergy (kWh)
In
p
ut
power.
Bypass Status Options
L-N voltage (V)
Line-neutral voltage of bypass power.
Fr
equency (Hz)
Frequency of bypass power.
Battery Status Options
Battery status
Current battery state: no battery,oat charging,equal charging,discharging,fully-charged,idle,test
Bat
tery voltage (V)
Voltage of battery power.
Battery current (A)
Current of battery power.
Backup time (Min)
Amount of back-up time remaining for battery.
Remaining capacity (%)
Percent of capacity remaining for battery.
Discharge count
Number of discharges for the battery module.
Total discharge time (Min)
Number of minutes until battery is fully discharged.
The number times that the input voltage was lost or dropped below 60 VAC (black out). Resets to
when UPS is powered down.
The number of times that the input voltage was too low to support the load and the UPS was forced to
switch to battery power (brown out). Resets to 0 when the UPS is powered down.
Input blackout count
Input brownout count