4 iGrowSeries 100 Installation Manual 960-0001-20
Mounting the iPonic 600
1. First, find a secure location to mount the iPonic 600
controller. The area should be away from
direct sunlight, condensing humidity, water, rain, or extreme temperatures. It should be
mounted in an easily accessible location at the user‟s eye level.
2. Since the iPonic 600
is equipped with a hinged door and a hinged access panel for easy service and
installation, make sure there is adequate workspace, especially below the controller.
3. The iPonic 600
comes with a 115 VAC power cord. Make sure there is a power outlet within
approximately 6 feet. It is recommended that the outlet is not switched and is on a circuit that is
independent of any noisy, high power equipment. The use of a sealed outlet is recommended if the
power output is exposed to moisture.
4. Identify what type of surface you will be mounting the iPonic 600
and use appropriate hardware to
ensure proper mounting and load bearing. Consider the additional weight of the external equipment‟s
power cords.
5. There are 4 mounting holes on the outside of the iPonic 600
. Use the appropriate tools and
hardware depending upon the surface which the unit will be mounted on to.
To Next Page
Loading...