Using the PC/Mac Client Software
16
3. In the Interval drop-down menu, enter the duration the DVR must wait before sending
out a new notification. For example, if you select a 3 minute interval, the DVR will send
out email notifications every 3 minutes until the DVR stops detecting motion. The DVR
will only send out notifications when it detects motion.
4. Click Save to save your settings.
If you select "Enable", and want to use your own email server:
1. Configure the following:
• SSL: Select ON/OFF to enable/disable Secure Socket Layer protocol.
• SMTP Port: Enter your SMTP address.
• SMTP Server: Enter your SMTP Server.
• Sender Email: Enter the sender email address. This can be any address of your
choice.
• Sender Password: Enter your email server’s password.
• Receiver Email: Enter the recipient’s email address.
• Interval: Enter the interval the DVR waits before sending a new email notification.
2. Click Save to save your settings.
16.17 Configuring DDNS Settings
The primary connectivity option uses Lorex Stratus Connectivity to connect to your system
over the Internet without requiring port forwarding or DDNS registration (see 15 Connect-
ing to Your DVR Over the Internet on PC or Mac for details). Lorex DDNS is also available
as an optional connectivity option (see 21 DDNS Setup—Access your DVR Remotely over
the Internet, page 144 for details).
To configure DDNS settings:
1. Visit http://www.lorexddns.net and register for a free DDNS account.
2. Click the Remote Setting tab, and click DDNS.
3. Configure the following:
• DDNS: Select Enable or Disable.
• Server: drop-down menu, select LOREXDDNS.
• Domain Name: Enter your Domain name/URL Request from the confirmation
email that was sent after you created your DDNS account.
• User name: Enter your DDNS User Name that was emailed to you after DDNS
registration.
• Password: Enter your DDNS Device password that was emailed to you after
DDNS registration.
#LX400080; r.36800/36800; en-US
80
To Next Page
Loading...
Need help?
General