14
RECORDING
By default, the system is set to immediately record video from connected cameras in Continuous
Record Mode.
You can set the system to stop recording once the hard drive is full, or to continually record by
overwr
iting previously recorded data.
For more details, see “Record” on page 25.
Event Recording
The system includes three modes of event recording:
• Motion: The syst
em records when motion is detected by the affected camera.
• Alarm: The system records when an alarm or sensor is triggered.
• Video Loss: The system records when a camera is disconnected or suffers video
loss. The system employs a pre-record function to capture video seconds before
the video loss occurred.
Recording Audio
The system can record two audio channels. You must have audio enabled cameras connected to
the system in order to use this function.
To Next Page
Loading...
Need help?
General