58
Appendix B: Setting up Local and Remote Viewing
How do I enable DDNS on my system?
Once you have registered for free DDNS service, use the information in the confirmation email to
configure DDNS settings on your system.
To enable DDNS on your system:
1. Open Internet Explorer (version 6 or above) and enter the IP address of your
DVR in the
address bar (i.e. 192.168.xxx.89). DVR Netviewer opens.
2. Login using your LAN user ID and
password (by default, ID 9; password 3333).
3. Click the Setup butt
on. The Setup menu opens.
4. Under Network, click DDNS.
5. Under DDNS
Select, click the drop-down menu and select http://lorexddns.net
6. In the corresponding text fields, enter your DDNS username and password.
NOTE:
Obtain this information from the confirmation email after registering for the free Lorex DDNS
service.
7. Under DDNS Domain Name, enter only the first portion of your DDNS domain from the
confirmation email. For example, if your domain name is tomsmith@lorexddns.net, you only
need to enter
tomsmith
in the text field.
8. Click Submit to sav
e your settings or click Cancel to exit without saving.
NOTE:
Once you have saved your DDNS settings, your must reset your system in order for the changes
to take effect. Disconnect and reconnect the power cable from the rear panel to reset. Please allow 10~15
minutes for the DDNS servers to update with your new DDNS address.
Figure 25.3 DDNS setup in DVR Netviewer
ATTENTION: You
MUST
enter your DDNS
information
LOCALLY
before attempting
remote access.
To Next Page
Loading...
Need help?
General