1.3 Product setup and disposal
1.3.1 General safety standards
Read the following safety standards to avoid personal injuries and to prevent damages to this product or to
the devices connected to it. Use this product strictly in the indicated way to avoid damages.
Only the support staff is authorized to perform the setup and managing procedures.
Install the instrument in a clean, dry and safe place. Humidity, dust and extreme temperatures tend to ruin
or damage the instrument. In these particular environments, it’s recommended to install the instrument in
appropriate protective boxes.
Power the instrument properly. Observe the power voltage indicated for the instrument model owned.
Connect the instrument properly. Follow meticulously the wiring diagram provided with the equipment.
Do not use the product if a malfunction presence is suspected. If the existence of a malfunction is suspected,
do not power the instrument and ask for assistance to the qualified support staff.
Before any operation on electrical connections, power, sensors and communication devices:
- turn off the power
- discharge the accumulated electrostatic charges touching a conducting material or a grounded
device
Do not start up the product if water or condensing humidity is present.
Do not start up the product in an explosive atmosphere.
1.3.2
Mechanical installation and placing
Alpha-Log is usually used outdoor inside the appropriate protective boxes. However, indoor use is possible
by fixing the instrument on DIN bar or to wall. For its functioning it requires the dedicated power supply or a
photovoltaic module with the proper external battery (the charge controller inside the data logger manages
the recharging of the 12 V batteries only; the management of the 24 V batteries is optional and on request).
For the mechanical installation see the documentation provided with the equipment.
1.4 Disposal
This product is a high electronic content device. In accordance with environmental protection and recovery
regulations, LSI LASTEM recommends treating the product as a waste of electrical and electronic equipment
(RAEE). Its collection at the end of its life must be separated from other waste.
To Next Page
Loading...