EasyManuals Logo

LSI GS550 User Manual

LSI GS550
89 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #59 background imageLoading...
Page #59 background image
Installation 57
Automatic recording. A record is added at a specified interval. When the automatic re-
cording data logger mode is selected on menu page 4F1 (see step 3 above) press Next to
go to page 4F11) and then use Up and Down to adjust the record interval in minutes.
Important! Wind speed: the data logger recording mode must be set to automatic
recording to log the data required by the wind speed report feature of the Data Logger
Viewer software.
Automatic variation. A record is added when load increases by more than the operator
adjusted percentage. When the automatic variation data logger mode is selected on menu
page 4F1 (see step 3 above) press Next to go to page 4F11) and then use Up and Down
to adjust the variation threshold.
Automatic peak. In the automatic peak mode the data logger analyzes the measured
weight and records the peak value only. One threshold per load cell must be adjusted.
When the weight drops by more than the peak threshold the peak weight is recorded. Only
one event is recorded for each pick when the threshold is adjusted correctly. When the
automatic peak data logger mode is selected on menu page 4F1 (see step 3 above) press
Next to go to page 4F11) and then use Up and Down to adjust the peak threshold for the
first load cell. Press Next to repeat for the second load cell etc. Up to four load cells can be
programmed for automatic peak data logging.
User input. Available on request only, the status of all sensors is recorded on demand. A
custom hardware modification to the GS550 display is required and a normally open push
button must be installed on a digital input to the GS550 through a pre-determined wire of
the power supply and lockout cable.
All data. All communications between a display and its sensors are recorded.
Date and Time
Adjust the data logger date and time as required:
1. Press Menu Next Next Next Enter Next Next Next Next Next
Enter Next to go to menu 4F2) Adjust date.
2. The last two digits of the year should be flashing: use Up and Down to adjust the year.
3. Press Next to adjust the month.
4. The month should be flashing: use Up and Down to adjust the month.
5. Press Next to adjust the day.
6. The day should be flashing: use Up and Down to adjust the day.
7. Press Next to adjust the time.
8. The hour should be flashing: use Up and Down to adjust the hour from 00 (midnight) to 23 (11
pm).
9. Press Next to adjust the minute.
10. The minute should be flashing: use Up and Down to adjust the minute.
11. Press Next to adjust the second.
12. The second should be flashing: use Up and Down to adjust the second.
13. Press Enter to save any changes.
14. Press Exit three times to return to the operation display.
SkyAzúl, Equipment Solutions
www.skyazul.com
301-371-6126

Table of Contents

Other manuals for LSI GS550

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the LSI GS550 and is the answer not in the manual?

LSI GS550 Specifications

General IconGeneral
BrandLSI
ModelGS550
CategoryMonitor
LanguageEnglish

Related product manuals