60 The GS550 System
Program the listen only mode.
1. Press Menu → Next → Next → Next → Enter → Next → Next → Next → Next →
Next → Next → Next → Next → Enter to go to menu 4I1).
2. Use Up and Down to switch between “network controller” and “listen only” modes.
3. Press Enter to save any change.
4. Press Exit three times to return to the operation display.
When a display is adjusted to listen only mode the following message flashes three times
during the start-up routine: “The display is in listen only mode”.
Tip: To regain network control of programmed sensors adjust the GS550 to “network controller”
(menu 4I1, see the procedure above), shut the display off, and then start it again.
Repeater
Communication between a GS550 and a programmed sensor can be routed through a different
programmed sensor (repeater). This can be done either to extend the range of the network or to
assist communication around a large radio obstacle. The battery life of the sensor repeated
(source) will be reduced by about a year
*
. The battery life of the sensor repeater will be reduced to
35 days
†
. This function should not be used where it is not required.
Program a sensor repeater.
1. Press Menu → Next → Next → Next → Enter → Next → Next → Next → Next →
Next → Next → Next → Next → Enter → Next to go to menu 4I2) Set-up sensor re-
peater
2. Press Enter to go to menu 4I21) Select repeater.
3. Use Up and Down to program the radio id number of the sensor that will be the re-
peater.
4. Press Next to go to menu 4I22) Select source
5. Use Up and Down to program the radio id number of the sensor that will be repeated.
6. Press Next to go to menu 4I23) Enter to save The new network path
7. Press Enter to save the new network path. The following messages will be displayed
briefly:
8. “Parameters saved correctly”
9. “Communicating with remote sensor…”
10. “Configuration saved successfully”
11. Press Exit three times to return to the operation display
*
Repeated (source) battery life estimated for standard product, using new factory specified batteries
correctly installed, operating 32 hours per week. Individual results may vary with intensity of use,
environmental conditions and other factors
†
Repeater battery life estimated for standard product, using new factory specified batteries correctly
installed. Individual results will not vary with of intensity of use; individual results may vary with
environmental conditions and other factors.
SkyAzúl, Equipment Solutions
To Next Page
Loading...
Need help?
General
