LSI GS550 User Manual

Certification Notes 77
This device has been designed to operate with the antennas listed below, and having a
maximum gain of 3.0 dB. Antennas not included in this list or having a gain greater than 3.0
dB are strictly prohibited for use with this device. The required antenna impedance is 50
ohms.
To reduce potential radio interference to other users, the antenna type and its gain should
be so chosen that the equivalent isotropically radiated power (e.i.r.p.) is not more than that
permitted for successful communication.
Antenna List
LSI P/N: TA011
Description ¼ wave monopole
MFG Load Systems International
FCC ID: QVBGS050 IC: 7076A-ICGS050
RF Exposure Warning:
This product complies with FCC/IC radiation exposure limits set forth for an uncontrolled
environment. To comply with RF exposure requirements, the unit must be installed and op-
erated with 20 cm (8 inches) or more between the product and your body. This product
may not be collocated or operated in conjunction with any other antenna or transmitter.
This device has been designed to operate with the antennas listed below, and having a
maximum gain of 3.0 dB. Antennas not included in this list or having a gain greater than 3.0
dB are strictly prohibited for use with this device. The required antenna impedance is 50
ohms.
To reduce potential radio interference to other users, the antenna type and its gain should
be so chosen that the equivalent isotropically radiated power (e.i.r.p.)is not more than that
permitted for successful communication.
Antenna List
LSI P/N: TA011
Description ¼ wave monopole
MFG Load Systems International
Notes for CSA Class I, Division 1 and 2 Rated Equipment
W ARNING : Understand manual before operation.
W
ARNING : Replace batteries only in area known to be non-hazardous.
In all sensors except the
GS 050- CSA , use 3.6V lithium batteries model Tadiran TL -5930
In
GS 050- CSA anti-two-block switches, use only alkaline ‘C’ batteries model Duracell
1.5 volts
PC 1400.
W
ARNING : S UBSTITUTION OF COMPONENTS MAY IMPAIR INTRINSIC SAFETY .
W ARNING : S UBSTITUTION OF COMPONENTS MAY IMPAIR SUITABILITY FOR CLASS I,
DIVISION
2.
W ARNING : D O NOT remove power cable from display when on.
For sensors: use "T4" temperature code.
SkyAzúl, Equipment Solutions
www.skyazul.com
301-371-6126

LSI GS550 Specifications

General

Brand	LSI
Model	GS550
Category	Monitor
Language	English