Chapter 10 Example Program
10-25
(4) Writing P2P transmission/reception block
Write P2P TX/RX block as follows by using user definition communication segment written ahead.
Sequence Setting method
1
1. Double-click P2P block of P2P 01.
2. Input channel selected at P2P channel (user frame definition).
3. In case P2P function is TX frame, select SEND. In case P2P function is RX, select
RECEIVE.
4. Conditional flag is activated when P2P function is SEND.
5. Since it reads data every 1 second, use F93 as conditional flag.
6. Click Setting of RX frame and set save area of current temperature and setting value.
2 Execute Write Parameter and Enable Link.
(5) Checking TRX data
Check whether written frame is transmitted/received properly
Sequence Setting method
1
1. Select [Online]-[System Diagnsis] or click icon ( )
2. After clicking relevant module and click right button of mouse, select Status by
service or frame monitor.
3. When frame is not dealt with properly, unknown message is displayed.
2 Check device area by device monitor of XG-5000.
To Next Page
Loading...
Need help?
General
