LTV 1150 - Boots, New Installation

p/n 18603-001, Rev. C LTV
®
1200/1150 Ventilator Service Manual Page 8-13
Boots, New Installation
Parts Required for Installation: Tools required:
• LTV
®
1200 Protective Boot, Upper (1)
P/N 11421
32
• LTV
®
1200 Protective Boot, Lower (1)
P/N 11420
32
• LTV
®
1150 Protective Boot, Upper (1)
P/N 19033-001
• LTV
®
1150 Protective Boot, Lower (1)
P/N 19032-001
• Replacement Screws Kit, P/N 11149
Replace if damaged:
• Finish Washers (6) P/N 10191
33
, or
19119-001, or 19119-002
• Phillips screwdriver with
torque meter
To install the Upper Protective Boot
34
:
1) Carefully support the disconnected ventilator in an upright position on a clean, dry
surface.
2) Using a Phillips-head screwdriver, remove the two upper back panel pan-head and two
side panel flat-head mounting screws indicated in the illustration on the next page.
• Do not remove the mating finish washers.
3) Orient the upper boot over the ventilator as shown in the illustration on the next page.
Move the boot down into position on the top of the ventilator and align its four screw
holes with the corresponding holes in the ventilator back and side panels.
4) Insert and thread two 1/2” flat-head mounting screws with finish washers through the
screw holes in the sides of the upper boot, as indicated in the illustration on the next
page.
5) Insert and thread two 3/8” flat-head mounting screws with finish washers, through the
screw holes in the legs of the upper boot, as indicated in the illustration on the next
page.
WARNING
Specific boot screw location – Make sure that the correct screw is used before tightening
down. Using a screw of the wrong length in this location can cause the ventilator to
malfunction resulting in possible harm to the patient.
32
Contained in Pulmonetic Systems Protective Boots Installation Kit, P/N 11550
33
Contained in Pulmonetic Systems Replacement Screws kit, P/N 11149.
34
See Appendix E - Reference Information,
External Accessories Screw Location, Type and Length for additional information.