If the ping command fails, seek technical support.
17. Type and enter cd /dynastar
Response:
#
18. Type and enter pwd
Response:
/dynastar
19. Type and enter ls -l
Response:
total XXX
-rw-r--r-- 1 root other XXXX Jul 26 10:23 cnfgload.cmp
-rw-r--r-- 1 root other XXXXX Jul 26 10:23 config
20. Type and enter:
tftp X
Where: X = IP address of Ethernet port at the router. (For example, tftp
10.10.9.254)
Response:
tftp>
21. Type and enter:
binary
Response: tftp>
22. Type and enter:
put cnfgload.cmp
Response:
Sent XXXX bytes in XXX seconds
tftp>
23. Type and enter:
quit
Response:
#
24. On the Supervisor Console, display the Main Menu page if it is not already
displayed:
• If the * prompt is displayed, type and enter 9999 at the * prompt to display
the DynaStar Supervisor page. Continue with the steps below indicating what
to do if the DynaStar Supervisor page is displayed.
• If the DynaStar Supervisor page is displayed:
a. Type and enter secret (or the password set for your office) at the Enter
Password: prompt.
Response:
The Supervisor Console Types information appears.
NETWORK PROCEDURES
Procedure 3.5
235-200-150
October 2004
Page 3.5-4 Issue 3.00L
To Next Page
Loading...