3. Type and enter 0 for Ethernet
3
Response: The Ethernet Interface Parameters page is displayed. See Figure
3.5-1
4. On the Ethernet Interface Parameters page, specify the following information:
(Use TAB and Cursor keys to navigate among the fields.)
• IP Routing:, select Y (Use the return key to toggle between Y and N.)
• IPX Routing:, select N (Use the return key to toggle between Y and N.)
• Ethernet Bridging, select N (Use the return key to toggle between Y and N.)
• OSI Routing, select N (Use the return key to toggle between Y and N.)
5. Press the left arrow key.
Response: The cursor is positioned at Process selections (Y/N).
6. Type and enter Y.
Response: The Configure Port menu is displayed.
If fields on the Ethernet Interface Parameters page were changed,
the following messages are displayed.
Changes made for port 0
Config has changed: use CTRL-W to save
If fields on the Ethernet Interface Parameters page
were not changed since the fields were already
configured correctly, the following message is
displayed.
No changes made for port 0
7. If changes were made to port 0, save the changes to flash memory by entering
[ctrl] w
Response:
Saving configuration to Flash...
is briefly displayed, and then the Configure Port menu is displayed.
If changes were not made to port 0, entering [ctrl] w is not needed and will have no
affect.
8. Press the [Esc] key to return to the Configuration Commands menu.
Response: The Configuration Commands menu is displayed.
9. Type and enter 3 for Router.
Response: The Router Commands menu is displayed.
10. Type and enter 5 for IP port information.
Response: The IP Port Information menu is displayed. See Figure below for an
example of the menu with the field values.
3. Registered trademark of Xerox Corporation.
NETWORK PROCEDURES
Procedure 3.6
235-200-150
October 2004
Page 3.6-2 Issue 3.00L
To Next Page
Loading...