If the Remote Router was replaced, see “Restore the Configuration Settings for
the DynaStar 500 (Base/Growth) Router at the DRM Site,” Procedure 3.5.
29. Reset the date and time on the replacement Router.
a. If the Supervisor Console is not displaying the DynaStar Supervisor page,
type and enter 9999 at the * prompt to display the DynaStar Supervisor
page.
b. Type and enter secret (or the password set for your office) at the Enter
Password: prompt.
Response:
The Supervisor Console Types information appears.
c. Type and enter 2 (for VT100 or ANSI compatible) at the Enter Console Type:
prompt.
Response:
The Main Menu page is displayed.
d. Type and enter 4 for System functions at the Enter command number:
prompt.
Response:
The System Commands menu is displayed.
e. Type and enter 1 for Date & Time at the Enter command number: prompt.
Response:
The Change System Date & Time menu is displayed.
f. Type and enter the current date and time, pressing the <enter> key after
specifying each entry.
Example input for July 26, 2004; 1:08:00pm:
Current Date month: 7 (1-12)
day: 26 (1-31)
year: 4 (95-53)
Current Time hour: 13 (0-23)
minute: 8 (0-59)
second: 0 (0-59)
Response:
The cursor is positioned at the Process new date and time (Y/N): prompt.
g. Type and enter Y at the Process new date and time (Y/N): prompt.
Response:
The System Commands menu is displayed.
h. Press the <ESC> key to return to the Main Menu page.
i. Press the <ESC> key again to exit the Main Menu and display the DynaStar
Supervisor page.
NETWORK PROCEDURES
Procedure 3.15
235-200-150
October 2004
Page 3.15-6 Issue 3.00L
To Next Page
Loading...
Need help?
General