30. Verify connectivity between the ASM and the DRM through the replacement
Router by executing the following:
If a Host Router was replaced go to step 31.
If a Remote Router was replaced go to step 32.
31. If a Host Router was replaced:
a. From the ASM UNIX console, login to the ASM UNIX shell.
b. Use the ping command to verify connectivity between the ASM and the
replacement Host Router.
The format of the ping command is:
ping <IP address of replacement Host Router>
The value for the IP address of the replacement Host Router depends on the
Host Router that was replaced. Type and enter one of the following
commands that corresponds to the replacement Host Router (see Table
3.15-4):
235-200-150
October 2004
NETWORK PROCEDURES
Procedure 3.15
Issue 3.00L Page 3.15-7
To Next Page
Loading...