30. Close the bezel at the front of the AW. The bezel is closed by gripping the bezel at
the two finger holds and rotating it up to its closed position. See Figure 4.5.5-1
(Netra 240 Front Panel).
31. Enter the following command to logically connect the replacement disk to the
operating system.
cfgadm -c configure c1::dsk/c1t1d0
Note: If an error occurs indicating a failure to configure the scsi device, verify
that the replacement drive was properly inserted into the bay. Once the drive has
been properly inserted into the bay, you will need to re-execute the cfgadm
command using the "-f″ option to force the configuration. If the error persists,
seek technical assistance. Otherwise, continue with the next step.
32. Enter the following command to confirm that the replacement disk is now
connected to the operating system.
cfgadm -al
Response:
Ap_Id Type Receptacle Occupant Condition
c0 scsi-bus connected configured unknown
c0::dsk/c0t0d0 CD-ROM connected configured unknown
c1 scsi-bus connected configured unknown
c1::dsk/c1t0d0 disk connected configured unknown
c1::dsk/c1t1d0 disk connected configured unknown
c2 scsi-bus connected configured unknown
c2::rmt/0 tape connected configured unknown
33. Log off using the exit command.
34. To partition and propagate the system to the secondary disk, follow subprocedure
4.5.6, "Partition and Propagate the System to the Non-Active Disk".
Response:
The AW boots on the primary disk.
35. STOP. YOU HAVE COMPLETED THIS PROCEDURE.
ADMINISTRATIVE WORKSTATION MAINTENANCE
Procedure 4.5.5
235-200-150
October 2005
Page 4.5.5-6 Issue 3.00B
To Next Page
Loading...
Need help?
General