Note: If the indicator is not ON (lit blue), seek technical assistance.
28. Remove the defective secondary disk from the HDD 1bay (right disk). See Figure
4.5.5-3 (Netra 240 Disk Drive Access).
a. Push the disk drive catch to the right to release the drive handle.
b. Extend the drive handle to disconnect the drive from the system.
c. Holding the drive handle, remove the drive from the drive bay.
29. Install the replacement disk into the HDD 1bay (right disk). See Figure 4.5.5-3
(Netra 240 Disk Drive Access).
a. Push the disk drive catch to the right to release the drive handle if
necessary.
b. Holding the drive handle, push the drive into the drive bay until the metal
lever starts to close. This indicates that the hard drive has engaged with its
connector in the AW.
c. Lock the drive in the bay by pressing on the drive handle until the drive
catch closes.
Figure 4.5.5-3 —
Netra
240 Disk Drive Access
235-200-150
October 2005
ADMINISTRATIVE WORKSTATION MAINTENANCE
Procedure 4.5.5
Issue 3.00B Page 4.5.5-5
To Next Page
Loading...