19. Was rdldft invoked from the MCC?
If YES, exit from UNIX shell, type and enter: q and exit from the MCC Page 194,
type and enter: q
If NO, continue with the next step.
20. Did the switching module ODD backup tape read into the ODD partitions
successfully?
If YES, continue with the next step.
If NO, seek technical assistance.
21. Type and enter:
EXC:ENVIR:UPROC,FN="/no5text/bkup/clrlg";
Note: The Recent Change (RC) and Customer-Originated Recent Change
(CORC) log files in the system are no longer consistent with the ODD just read
in from tape. The AM Backout indicator should be returned to normal. This is
accomplished by first clearing the RC and CORC recent change log files (AM and
switching module) and then clearing the AM recent change backout indicator.
Response: EXC ENVIR UPROC /no5text/bkup/clrlg STOPPED rm:cni directory
OR
EXC ENVIR UPROC STOPPED (If log files do not exist) rm *
non-existent
22. Type and enter:
STP:EXC:ANY,FN="/no5text/rcv/lglog",UCL;
Response: REPT ULARP ATTEMPTING TO RESTART LGLOG xx STOP EXC
ANY COMPLETED
23. Clear backup schedule. Type and enter:
CLR:ODDBKUP;
Response: CLR ODDBKUP COMPLETED
24. Type and enter:
EXC:ODDRCVY=SKIPLOG,AM;
Warning: Inappropriate use of this message may interrupt or degrade
application service. Refer to 235-600-700/750, Input/Output Messages
Manual.
Response: EXC ODDRCVY=SKIPLOG AM COMPLETED
25. Type and enter: 521 to clear RC BKOUT box on MCC Page 110.
Response: RC BKOUT box clears.
Note: The AM is currently running on a different version of the ODD than the
switching module. To correct this situation, the switching module must be
initialized.
26. STOP. YOU HAVE COMPLETED THIS PROCEDURE. Return to “Post AM
Recovery Cleanup,” Subprocedure 7.2.1.
SYSTEM RECOVERY
Procedure 7.2.3
235-200-150
January 2003
Page 7.2.3-4 Issue 3.00
To Next Page
Loading...
Need help?
General