Note: An ! may be entered any time prompted to abort the form and return to
the state when the form was started.
(a) Type and enter: ttyadd
Response: ttyadd form displayed. Cursor at 1.tty_name:
Note: An ! may be entered any time prompted to abort the form and
return to the state when the form was started.
(b) Type and enter the following data:
1. tty_name
a
: enter TTY terminal name (TTY18, TTY19, or
TTY21)
2. baud_rate: enter (as specified or CARRIAGE RETURN)
3. login_term: enter (as specified or CARRIAGE RETURN)
4. auth_chk: enter (as specified or CARRIAGE RETURN)
5. term_type: enter (as specified or CARRIAGE RETURN)
6. line_mode: enter (as specified or CARRIAGE RETURN)
7. port: enter 2 or 3 for TTYC port (see Table 8.3-1 and
8.3-2)
8. ttyc_number: enter TTYC number base on SAI port (see Table
8.3-1 and 8.3-2)
9. plu_unit_name: enter CARRIAGE RETURN
10. plu_unit_number: enter CARRIAGE RETURN
Note(s):
a. tty_name must be entered in all capital letters.
(c) Type and enter: i
Note: When growing a TTY terminal a defensive check failure message
REPT CONFIG FAULT Assert = 412 may be received. This failure message
may be ignored.
4. Install the RC/V terminal to the SAI port corresponding to the TTYC port and
TTYC number chosen in Table 8.3-1 and 8.3-2 (see Figure 8.4-1 , 8.4-2 and 8.4-3).
(a) Enter CARRIAGE RETURN
2. Trademark of Sun Microsystems, Inc.
GROWTH AND DEGROWTH
Procedure 8.4
235-200-150
October 2005
Page 8.4-2 Issue 3.01
To Next Page
Loading...
Need help?
General