EasyManuals Logo

Lucent 5ESS DRM User Manual

Default Icon
642 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #443 background imageLoading...
Page #443 background image
IMPORTANT: To prevent unauthorized access to the DRM’s
Sun
console, set
per local guidelines.
17. If Modem B is a Paradyne 3810 modem, set the modem options on Modem B to
the same values as Modem A with the exception of the "DTE Dialer Type" field in
the "DTE_Dialer" submenu. For Modem B, "DTE Dialer Type" should be set to
Enable. If Modem B is not a Paradyne 3810 modem, follow the user manual
provided with the modem to provision it so that its communication parameters
(primarily the baud rate, parity, stop bits, and data bits) match that of Modem A.
18. Follow the user manual provided with the dial-up Sun console terminal or
terminal emulator software package to set the communication parameters on the
dial-up Sun console terminal to match those of the modems (for example, 9600
baud, 8 data bits, 1 stop bit, No parity).
19. Power up the AW units and dial-up Sun console hardware in the following order:
For a Netra t 1120 or Netra 20 workstation:
1. Local MCC/Sun console terminal
2. Modem A (Paradyne 3810)
3. Netra t 1120 and Netra 20 workstation. See "Restore Power to
Administrative Workstation (Netra t 1120 and Netra 20)", Procedure 4.8.
For a Netra 240 workstation:
1. Local MCC/Sun console terminal
2. Modem A (Paradyne 3810)
3. Netra 240 workstation and external tape device. See "Restore Power to
Administrative Workstation Units (Netra 240)", Procedure 4.10.
20. Verify that the local Sun console terminal is functional.
21. Verify that the Sun console can be accessed via the modem.
a. Power up the dial-up Sun console terminal and Modem B.
b. If the security options have not been set up on Modem A, type and enter:
ATDTxxxyyyy at the dial-up Sun console terminal.
where xxxyyyy = the phone number of the analog line connected to Modem
A.
If the security options are set up on Modem A to require a password for
connection, type and enter: ATDTxxxyyyyWaaaaaaaa#
where: xxxyyyy = the phone number of the analog line to Modem A, and
aaaaaaaa = the 8 digit numeric password.
c. Wait for Modem A to be dialed and then verify that the Sun console pages
can be accessed once the modem connection is established.
235-200-150
October 2005
GROWTH AND DEGROWTH
Procedure 8.6
Issue 3.00B Page 8.6-5

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Lucent 5ESS DRM and is the answer not in the manual?

Lucent 5ESS DRM Specifications

General IconGeneral
BrandLucent
Model5ESS DRM
CategoryControl Unit
LanguageEnglish