117 –– Plant measurement database monitor (PLDMON).
186 –– Kernel level overload monitor (KLMON)
188 –– UNIX RTR operating system supervisor overload
monitor process (SUOVPRC).
406 –– Process to load ODD onto Disk (PLOD).
407 –– Application data link (APDL).
410 –– Switch maintenance kernel process (SMKP).
411 –– Switch maintenance power switch monitor
(SMPSM).
420 –– Communications kernel process (CMKP).
430 –– Message switch kernel process (MSKP).
450 –– Pump control (PUCR).
460 –– Operational Kernel Process (OKP)
590 –– Process for loading ODD into PAS (PLOP).
710 –– Switch Maintenance Diagnostic Input Message
Processor (SMDIMP). SMDIMP is also referred to as
deferred maintenance administrator and monitor (DMAM).
7ED –– Communications Module Processor Kernel Process
(CMPKP)
7DD –– Automatic Message Accounting Disk Writer 1
(AMDW1).
7CE –– Automatic Message Accounting Disk Writer 2
(AMDW2).
i = Initialization sequence state:
00 — Created (booted from disk).
01 — Software initialization.
02 — Hardware initialization.
03 — Communication link initialization.
04 — Enable fault recovery
05 — Essential jobs operational.
06 — Fully operational.
07 — Aborting
j = Success/failure indication:
0 — Initialization step completed successfully.
1 — Initialization step failed.
2 — Initialization step timeout.
3 — Initialization step in-progress.
4 — Initialization step not attempted.
A — Process abort or re-initialization starting.
B — Initialization step beginning (use EAI page poke
42;J;50 to turn on).
D — Death of child received for this process.
kk = Initialization progress points:
APPENDIX 2
PROCESSOR RECOVERY MESSAGES
235-200-150
January 2003
Page A2-6 Issue 3.00
To Next Page
Loading...