00 –– Normal operation (no initialization or safe interval).
01 –– AIM created.
02 –– 5E critical creations requested (phase 1 creations in
progress).
03 –– DB/DD initialization complete.
06 –– SMKP SOFTINIT completed.
07 –– MSKP SOFTINIT completed.
08 –– OKP SOFTINIT completed.
10 –– DRM call processing on.
40 –– Call support creations requested (phase 4 creations
in progress)
60 –– ULARP HM processes created.
80 –– ULARP MTCE processes created.
A0 –– DRM/UNIX RTR operating system non-critical
creations requested (phase 5 creations in progress).
E4 –– ULARP RC/DB processes created.
F4 –– ULARP AS/TM processes created.
FF –– ULARP deferred processes created (begin safe
interval).
hh hh hh = Hardware status digits. Refer to Figure A2-1 for definition
of the digits.
A2.2.2.5 Explanation
AIM prints these PRMs as the UNIX RTR operating system application processes
complete (or fail to complete) each of their required initialization sequence states.
A2.2.2.6 Corrective Action
None. These PRMs are informational only. Other failure PRMs will be printed if
operator actions are required.
235-200-150
January 2003
APPENDIX 2
PROCESSOR RECOVERY MESSAGES
Issue 3.00 Page A2-7
To Next Page
Loading...