0420 –– Communications kernel process (CMKP).
0430 –– Message switch kernel process (MSKP).
0450 –– Pump control (PUCR).
0460 –– Operational kernel process (OKP).
0590 –– Process for loading ODD into PAS (PLOP).
0710 –– Switch Maintenance Diagnostic Input Message
Processor (SMDIMP). SMDIMP is also referred to as
deferred maintenance administrator and monitor (DMAM).
7ED –– Communications Module Processor Kernel Process
(CMPKP)
07DD –– Automatic message accounting disk writer 1
(AMDW1).
07CE –– Automatic message accounting disk writer 2
(AMDW2).
yy = Failed process sequence state:
00 –– Created (booted from disk).
01 –– Software initialization.
02 –– Hardware initialization.
03 –– Communication link initialization.
04 –– Enable fault recovery.
05 –– Essential jobs operational.
06 –– Fully operational.
07 –– Aborting.
zz = Reason for failure.
0b –– initialization time limit exceeded.
0c –– initialization sequence state failed or timed out
(INSEQSTFL)
hh hh hh = Hardware status digits. Refer to Figure A2-1 for definition
of the digits.
A2.2.3.5 Explanation
The AIM process produces this PRM when a killable process reports the failure of an
initialization sequence state, or when a killable process times out while initializing.
A2.2.3.6 Corrective Action
The killable process that failed should be re-initialized manually.
235-200-150
January 2003
APPENDIX 2
PROCESSOR RECOVERY MESSAGES
Issue 3.00 Page A2-9
To Next Page
Loading...