p = Active control unit (CU):
0––CU0
1––CU1
v = E - Administrative Module (AM) software checks are
inhibited (see “Explanation,” Section A2.2.8.5).
F - AM software checks allowed. A high level AM
initialization will follow immediately.
E = Application software generated this PRM.
d = Level of most recent UNIX RTR operating system
initialization:
0 –– No initialization or D0 initialization.
1 –– D1 initialization.
2 –– D2 initialization.
3 –– D3 initialization.
4 –– D4 initialization.
These initializations are explained in 235-105-250, 5ESS
Switch System Recovery Manual.
a = Application initialization level within the UNIX RTR
operating system initialization specified in field ’d’.
FF1B = Application function = DRM phase trigger = FPI request.
wwww = UNIX RTR operating system application process utility ID:
0017 –– First in-first out (FIFO) driver (FDA).
00C0 –– Input/output driver (IODRV).
00C2 –– Scan and signal distributor administration
(SCSD).
0CC –– RTR Data Link Driver for DRM
0117 –– Plant measurement database monitor (PLDMON).
0186 –– Kernel level overload monitor (KLMON)
0188 –– UNIX RTR operating system supervisor overload
monitor process (SUOVPRC).
0406 –– Process to load ODD onto Disk (PLOD).
0407 –– Application data link (APDL).
0410 –– Switch maintenance kernel process (SMKP).
0411 –– Switch maintenance power switch monitor
(SMPSM).
0420 –– Communications kernel process (CMKP).
0430 –– Message switch kernel process (MSKP).
0450 –– Pump Control (PUCR)
0451 –– Automatic Message Accounting Disk Writer
(AMDW).
0460 –– Operational kernel process (OKP).
0590 –– Process for loading ODD into PAS (PLOP).
APPENDIX 2
PROCESSOR RECOVERY MESSAGES
235-200-150
January 2003
Page A2-18 Issue 3.00
To Next Page
Loading...