0710 –– Switch Maintenance Diagnostic Input Message
Processor (SMDIMP). SMDIMP is also referred to as
deferred maintenance administrator and monitor (DMAM).
7ED –– Communications Module Processor Kernel Process
(CMPKP)
07DD –– Automatic message accounting disk writer 1
(AMDW1).
07CE –– Automatic message accounting disk writer 2
(AMDW2).
x = Failed process sequence state.
0 –– Created (booted from disk).
1 –– Software initialization.
2 –– Hardware initialization.
3 –– Communication link initialization.
4 –– Enable fault recovery.
5 –– Essential jobs operational.
6 –– Fully operational.
7 –– Aborting.
y = Run state.
0 –– Running.
1 –– Step done.
zz = Error code:20 - INcomplete () failure or timeout (s5 or
lower).
22 — Manual "INIT:AM,FPI" request was made. See
235-600-700, Input Messages Manual.
23 — Process Manager (PMGR) death of child message
received.
24 — FPI retry requested on process that failed during
Administrative Module (AM) initialization.
hh hh hh = Hardware status digits. Refer to Figure A2-1 for definition
of the digits.
A2.2.8.5 Explanation
AIM prints this PRM to report a request to perform a Full Process Initialization (FPI)
on the specified UNIX RTR operating system application process. This level of
initialization is also known as an S5 initialization.
If the FPI was not manually requested, AIM may select a more severe recovery action
based on the state of the system and the extent of previous recovery attempts. If the
number of attempted FPIs exceeds a threshold and AM software checks are allowed,
AIM will trigger a high-level AM initialization. Otherwise, no initialization will occur.
However, the system may not support essential functionality (such as call processing,
maintenance, or input/output).
235-200-150
January 2003
APPENDIX 2
PROCESSOR RECOVERY MESSAGES
Issue 3.00 Page A2-19
To Next Page
Loading...