The CALL MONITOR indicator shows whether the Call Monitor is inhibited or
allowed. Entering the command 601 generates the message INH:CALLMON which will
inhibit the monitor from making test calls and performing call completion analysis.
This also clears the monitor’s history data. The command 701 generates the message
ALW:CALLMON which allows the monitor to start the cycle of making test calls and
performing call completion analysis. Command 801 generates the message
RTR:CALLMON,ALARM which retires the alarm indicator in the Call Monitor box.
Command 901 generates the message OP:CALLMON which generates the OP
CALLMON PAST 15 MINUTE REPORT on the ROP.
The indicator GENERIC RETROFIT will backlight and change to GENERIC
RETROFIT ACTIVE when software release (generic) retrofit is in progress.
The indicator ODD EVOLUTION will backlight and change to ODD EVOL ACT when
ODD Evolution is in progress. ODD Evolution is initiated by the command
BKUP:ODD,ODDEVOL and stays in effect until the actual software release cut-over
takes place.
The indicator ODD WARNING will backlight when either the amount of ODD space
being used has exceeded the engineering recommendations for the AM or the
automatic relation engineering reorganization process has failed on one or more
relations in the AM. Entering the command 902 generates the input message
OP:ODDWARN,AM which will generate the OP ODDWARN output message on the
ROP.
The RCLOG WARNING indicator will backlight when the recent change log reaches
80 percent full. Enter poke 903 to output the recent change log status. To clear a
RCLOG WARNING, perform Backup ODD.
The RCLOG WARNING indicator is provided on the 116 page. A major alarm occurs
and this indicator is backlighted when the RC log files approach full capacity. The 903
poke provides additional information.
SYS EMER CRITICAL MAJOR MINOR CKT LIM SYS NORM
OVERLOAD SYS INH AM AM PERPH OS LINKS SM MISC
CMD< 116 - MISCELLANEOUS
601 CALL MONITOR CALL MONITOR SM FILE NORMAL
MTIB SEE PAGE 127
INHIBIT ALARM
CUTOVER
SEE PAGE 197
701 CALL MONITOR
BWM AUTOMATION
GENERIC RETROFIT SEE PAGE 1941
801 CALL MONITOR ALM ODD EVOLUTION
ODD WARNING RCLOG WARNING
901 CALL MONITOR RC BACKUP NORMAL
902 ODD WARNING
903 RCLOG WARNING
INHIBIT
ALLOW
RETIRE
OUTPUT
Figure 2-36 — Miscellaneous Status Summary - MCC Display Page 116
5ESS
®
SWITCH DISTINCTIVE REMOTE MODULE 235-200-150
Feburary 2007
Page 2-46 Issue 3.00O
To Next Page
Loading...
Need help?
General