LUMENIS SELECTA - Page 120

Selecta
PBL200051, Rev J
120  Appendix 1
Guidance and Manufacturer's Declaration: Electromagnetic Immunity
Selecta ophthalmic laser family is intended for use in the electromagnetic environment specified below. The customer or the
user of Selecta ophthalmic laser family should ensure that it is used in such an environment.
Immunity Te s t I E C 60601 Te s t
Level
Compliance Level Electromagnetic
Environment: Guidance
Electrostatic Discharge (ESD)
IEC61000-4-2
±6kV
contact
±8kV air
Class A Floors should be wood, con-
crete,
or ceramic tile. If floors
are
covered with synthetic
material, the relative humidity
should
be at least
30%.
Electrical fast transient/burst
IEC61000-4-4
±2 kV for power supply lines
±1kV for input/output lines
Class A Mains power quality should be
that of a typical commercial
or
hospital environment.
Surge
IEC61000-4-5
±1kV
line(s) to line(s)
±2kV line(s) to earth
Class A Mains power quality should be
that of a typical commercial
or
hospital environment.
Vo l t a g e
dips, short interrup-
tions
and voltage variations on
power supply input lines
IEC61000-4-11
<5% U
T
(>95% dip in U
T
) for
0.5 cycle
40%
U
T
(60% dip in U
T
) for 5
cycles
70%
U
T
(30% dip in U
T
) for 25
cycles
<5%
U
T
(>95% dip in U
T
) for
5 sec.
Class A
Class A
Mains
power quality should be
that of a typical commercial
or
hospital environment. If
the user of Selecta oph-
thalmic laser family requires
continued operation during
power
mains interruptions, it
is recommended that Selecta
ophthalmic laser family
be
powered from an uninterrupt-
ible power
supply or a bat-
tery.
Power
frequency (50/60Hz)
magnetic
field
IEC
61000-4-8
3
A/m N/A Power-frequency magnetic
fields should be at levels char-
acteristic
of a typical location
in a typical commercial or
hospital environment.
NOTE:
U
T
is the a.c. mains voltage prior to application of the test level.