System Basics 47
Selecta
PBL200051, Rev J
System beeps
The system emits unique beeps to distinguish certain types of events. For
example, the system beeps when the standby or ready laser status mode is
changed, when the system is not ready to accept input, when the maximum or
minimum treatment setting is reached, when the energy delivered was less
than requested, or when an error has occurred.
Disconnecting the system
1 Turn the keyswitch to the (off) position.
2 Remove the system power plug from the electrical outlet.
Moving the system
After disconnecting the system, move the slit lamp table and accessories to the
desired site. Step on the wheel brake to lock the wheel, as shown. To unlock
the wheel, place your foot under the brake and lift the lever up.
Locking the wheels
O
To Next Page
Loading...
