Selecta
PBL200051, Rev J
90 Maintenance
Energy Calibration
Energy calibration should be performed annually by a Lumenis-certified
service engineer to ensure proper laser performance. Calibration must be
performed by an engineer or technician qualified to work on energized
electronic laser equipment. Calibration questions should be referred to your
local Lumenis representative.
Disclaimer warning
Calibration is a service procedure to be done only by Lumenis-certified service
engineers or customers who have taken and passed a Lumenis Service
Certification Training course. Adjustment by anyone other than a trained
Lumenis service engineer or a certified customer voids any existing
manufacturer’s warranty on the instrument. A service manual for the laser may
be purchased from Lumenis. It is company policy not to distribute service
tools outside of the Lumenis service organization. Possession of service
instructions or tools does not authorize repair or modification of a Lumenis
instrument by uncertified personnel.
To Next Page
Loading...
