Laser Basics 59
Selecta
PBL200051, Rev J
Aiming beam
The aiming beam intensity can be adjusted with the aiming beam intensity
control knobs located on the slit lamp (shown on the “Slit Lamp Controls”
illustration), or by using the remote control aiming beam pushbutton. To
decrease the intensity, press the lower portion of the button. To increase the
intensity, press the upper portion of the button.
Adjusting the aiming beam intensity
(Photodisruptor screen shown)
Increase intensity
Decrease intensity
Aiming beam
intensity display
To Next Page
Loading...
