LUMENIS SELECTA - Attaching the Laserlink S Delivery Device

Selecta
PBL200051, Rev J
40  Operation
Attaching the LaserLink S delivery device
CAUTION - Before use, refer to the LaserLink S Operator Manual for
detailed installation and operation instructions.
1 Position the illumination tower out of the way.
2 Place the LaserLink S on top of the Selecta Slit Lamp.
3 Secure the LaserLink S with the attached thumb screw.
4 Verify that the Remote Control shows the LaserLink icon and does not allow
the system to display YAG or SLT functions.
5 Replace the Selecta Slit Lamp’s single illumination mirror with the dual
illumination mirror.
6 Attach the LaserLink S fiber optic to the photocoagulator, as described in the
LaserLink S operator manual.
7 Disconnect the external door interlock plug from the Selecta and connect the
plug to the photocoagulator when the LaserLink S is connected and in use.
Re-connect the external door interlock plug to the Selecta when the
LaserLink S and photocoagulator are no longer in use.