MacDon 9200 - Maintenance;Service; Service Procedures

MAINTENANCE/SERVICE
Service Procedures
CAUTION: To avoid personal injury,
before servicing machine
or
opening drive covers:
1. Fully lower header and reel.
2. Disengage header drive clutch.
3. Stop engine and remove key.
4. Engage park brake.
5. Wait for aU moving parts to stop.
Wear close ~ fittlng clothing and cover long
hair. Never wear dangling items such
as
scarves or bracelets.
Wear protective shoes with slip-resistant
sales, a hard hat, protective glasses
or
goggles and heavy gloves .
Be prepared if an accident should occur.
Know where the first aid kit and fire
extinguisher are located and how to use
them.
Keep the service area clean and dry. Wet or
oily floors are slippery . Wet spots can be
dangerous when working with electrical
equipment. Be sure all electrical outlets and
tools are properly grounded.
Use adequate light for the job at hand.
Park
on level surface when possible. Block
wheels securely.
Replace
all shields removed or opened for
service.
Use
only service and repair parts made or
approved by the equipment manufacturer.
Substituted parts may not meet strength,
design or safety requirements.
Keep the
wind rower clean. Do not allow oil or
grease to accumulate on the service platform,
ladder
or controls.
Never use gasoline, naphtha or any volatile
material
for cleaning purposes. These
materials may be
toxic and/or flammable.
52
STAY CLEAR OF DRIVELINE
A ND ALL MOVING PARTS
)