MacDon 9200 - Unloading

UNLOADING
A
WARNING: To avoid personal injury
or death do not attempt to drive the
wind rower off the carrier. It must be
lifted or towed. When starting the
windrower,
slight movement of the steering
wheel could cause fast and hard-ta-correct
movement on a small surface such as a trailer
bed. This could cause the machine to fall
from the carrier onto the ground.
Prepare to Unload
A
CAUTION: To avoid injury to
bystanders from being struck by
machinery, do not allow persons to
stand in the unloading area.
1. Move trailer into position
and block traiter
wheels.
2. Lower trailer storage stands.
A
CAUTION: Unloading equipment
must meet or exceed the specified
requirements. Using inadequate
equipment
may result in vehicle
tipping or machine damage.
Two Forklift Method
Two forklifts,
,u. \ •• =7_ , capacity and
1. Set forklift tines to the widest possible setti ng .
2. Position one forklift on either side of trailer
bed .
NOTE: Wind rower center of gravity is
approximately 48 inches (1220 mm) rearward
of drive wheel center.
3. Place forks under wind rower frame on both
sides.
4. Lift with both forklifts simultaneously until
wind rower is clear of trailer bed .
5. Drive truck slowly forward until trailer bed is
clear of windrower.
6. Lower unit slowly and simultaneously with
both forklifts to approximately 24 inches (600
mm) from ground.
7. I nstall front and rear tires. See "Tires" in
Assembly section.
S. Lower unit to ground.
130
PREPARE TO UNLOAD
)
UNLOADING WITH TWO FORKLIFTS